Domestic electrical work inStevenage and across Hertfordshire,done properly and left tidy

These are the most common domestic call-outs: a dead socket, a cracked switch plate, an extra socket needed for a new appliance. Cable is matched to the circuit's existing rating, and any signs of an underlying fault, scorch marks, loose terminals, are flagged rather than just covered over.

These jobs are usually quoted from photos. The £120 call-out charge includes the first hour on site, with £50 per hour after that for anything that takes longer.

A split-load 10-way consumer unit starts from £695 + VAT. Modern units use RCBOs on each circuit, which means a fault on one circuit trips only that circuit rather than cutting power to the whole property.

This is notifiable work under Part P, so it's certified and registered correctly once complete. Hager fuseboards, as an example, may carry around a 1-year manufacturer warranty on top of the 12-month workmanship guarantee.

A full rewire replaces all the cabling, sockets, switches and the consumer unit: typically needed in older properties or ahead of a major renovation. A partial rewire targets specific circuits or rooms, useful where only part of the property has an issue.

Rewires involve lifting floorboards and chasing walls where needed, so the property is protected with dust sheets and left tidy at the end of each day, not just at the end of the job.

Internal lighting work covers everything from a single pendant to multi-circuit downlight installations, including two-way and multi-way switching. Outdoor lighting needs IP-rated fittings and armoured or SWA cable where it's buried, since standard indoor cable isn't rated for underground or damp use.

Garden sockets, outdoor power for sheds or workshops, and security lighting are all wired back through RCD-protected circuits for safety.

New-build properties sometimes have switches wired to the wrong lights, missing circuits, or sockets that don't work; this gets diagnosed and corrected as part of a wider fault-finding visit rather than guesswork.

Fault finding starts with isolating circuits and testing, rather than replacing parts speculatively, which keeps the cost down and finds the actual cause.

Most domestic properties run on a single-phase supply, which keeps the installation relatively straightforward compared with commercial sites. Even so, loads have grown over the years with more appliances, home office equipment and EV chargers than older consumer units were ever designed for.

Where a domestic property also has an annexe, home office or outbuilding used for business, the wiring sometimes needs to be split or protected differently to reflect that mixed use; this gets picked up and discussed during the initial visit rather than assumed.